OLS1 LED Light Source

ols1

  • Cost effective โ€“ LED Source

    NOYES OLS1 from AFL is two port multimode LED source for testing multimode fiber links.ย  Packaged in a rugged hand-held case The OLS1 is designed for technicians on the go.ย  The LED output is stabilized to ensure accurate test results per current TIA/EIA requirements.

    Low Training Requirements: The OLS1 is easy to operate with only a [Wavelength/ Power] switch, which selects optical wavelengths or disables unit.

    LED indicators [Active Output], [Battery], and [External Power] identify the currently enabled output port, battery level, and external power presence.

    Weighing only 0.65 lb, the OLS1 is compact and convenient for field use. The OLS1 from AFL operates over 60 hours from a typical 9V alkaline battery. An AC adapter is optional for extended use.

    50 and 62.5 ยตm fiber mandrels Included

    Mandrels condition test cable for use in certifying both 50 and 62.5 ยตm fiber links for current and planned high bit rate applications including Gigabit Ethernet and 10 Gigabit Ethernet.ย ย Mandrels apply to launch jumpers is seconds without tools and ensure loss measurements comply with TIA/EIA-568-B standard.

    The OLS 1 light source is fully N.I.S.T. traceable.

    • 5-Year Product Warranty
    • 3-Year Recommended Calibration Interval
    • 850 and 1300 nm LED (multimode) light source
    • 660 and 850 nm LED light source available
    • Gigabit Ethernet (GBE) ready
    • Certify 50 or 62.5 ยตm fiber links to TIA/EIA Standards
    • Certify Multimode fiber links for Gigabit Ethernet (GBE)
    • Test Ethernet, Token Ring, and FDDI fiber networks
    • Use 1300 nm port to test up to 10 km single-mode fiber links
  • OLS1-1C
    • Wavelengths: 660 nm (Red) and 850 nm
    • Output Power: -10 dBm into 1000 micron fiber / -20 dBm into 62.5 ยตm multimode

    OLS1-2C

    • Wavelengths: 850 and 1300 nm
    • Output Power: -20 dBm into 62.5 ยตm multimode

    OLS1 Models

    • Output Connectors: ST
    • Battery: 9V Alkaline